Sip-n-Puff Tubing Kit with Mouthpieces, & Accessories – Vacuum Packed

Required with any pneumatic switches or as a replacement. Turn your favorite headset into a Sip-n-Puff Headset. Works great on any flex arm mount. Includes Sip-n-Puff Tubing, Mouthpieces, Bite Bulbs, & Attachment Accessories.

Features 2 replaceable Anti-Contamination Filters Mouthpieces. 1.2 µ HEPA Rated (removes 99.9% bacteria & viruses) and Hydrophobic (blocks moisture in breath or saliva). These are the same high-tech materials and filter elements used on ventilators and blood transfer devices in hospitals as well as food processing equipment.

Kit Contents

• 10′ 1/8″ ID PVC Tubing – Cut into two 5-foot or three 3.3-foot pieces. Replace when it becomes dirty or between users.
• 18″ stainless steel wire – Insert inside tubing before mouthpiece receiver to make it positionable. Will not rust. Can be washed in soapy water when replacing the tubing.
• 1 Mouthpiece Receiver for ⅛” Tubing – Insert barb into the end of the tubing. Blue mouthpiece disc inserts into the receiver with a ½ twist
• 1 Straight Anti-Contamination Mouthpiece
• 1 Curved Anti-Contamination Mouthpiece – Use a curved mouthpiece on a headset microphone arm and a straight mouthpiece on a flex arm mount. Mouthpieces are both hydrophobic (block all moisture from breath or saliva) and 1.2 µm HEPA rated (block 99.9% of bacteria and viruses). Replace monthly or between users. 12 Packs available SKU SwP1282.a
• 3 Bite Bulbs – Insert into the end of a mouthpiece or tubing to use as a bite switch. Replace between users. 25 Pack available SKU SwP1285.a
• 1 Large Squeeze Bulb – Insert into the end of mouthpiece or tubing to squeeze in hand as a grip switch, position on wheelchair footplate with velcro straps and compress with the foot, or position on wheelchair armrest with velcro straps and compress with a side of the fist, forearm, or elbow.
• 3  Velcro Bundling Wrap Strips – to hold tubing along the side of a flex arm mount, wheelchair, etc
• 3 Black Plastic Zip Ties – alternative to velcro bundling rap strips to hold or position tubing
• 2 Shirt-front Clips – snap around tubing to clip to front of shirt
• 1″ Adhesive Mounting Pad – slide a black plastic zip tie through it to hold tubing to the side of Quadmouse or any flat surface
• 5″ inch piece of 3/4″ diameter heat shrink – slide over the microphone arm on a headset as pictured above, then insert tubing through heat shrink with white mouthpiece receiver just outside the heat shrink. Shrink with a lighter, match, strong hair dryer, or heat gun. Remove heat as soon as it shrinks, excessive heating will not cause it to shrink more but only burn.
• Vacuum Sealed – maintain clean until ready to use

*Compatible Pneumatic Switches 

• Sip-n-Puff Switch
• Sip or Puff Nurse Call Switch
• In-line Puff Switch
• In-line Nurse Call Puff Switch

** Mouthpieces are available separately in 25 packs. Mouthpiece filters should be replaced between users or monthly with the same user