Game Boy Color TFT LCD Backlight Kit – Cloud Game Store

An easy to use kit to upgrade your Game Boy Color. This “Cloud” version is yet another type of IPS backlight you can buy for your Game Boy.

FEATURES:

• Display is transflective, meaning it works wonderfully in direct light!
• No shell modification required for regular GBC Shells
• Beautiful LCD with backlight
• Includes shielding sticker for the back of the PCB
• Brightness adjustment without soldering wires
• Double sided foam adhesive is not required and is meant to help center LCD if not using spacers. 
• We recommend using the included ‘TFT brackets’ instead of the ‘acrylic spacer’.

INCLUDED:

• 1x TFT LCD
• 1x PCB
• 1x Adhesive
• 1x Insulation film
• 1x Ribbon
• 1x Touch sensor ribbon
• 1x Set of TFT brackets
• 1x Acrylic spacer

PAIRS WELL WITH:

• Game Boy Color TFT Screen Lens – Glass
• Game Boy CleanAmp v1.1 Audio Amplifier
• Game Boy Color Replacement Shell

DOCUMENATION:

• Install Guide
• How to test your LCD kit

NOTES:

• The display area on the LCD is slightly smaller than the original so a TFT lens must be used to mask properly. 
• This LCD no longer has a protective film on it. Do not attempt to peal anything off the LCD as this results in removing the polarizer.
  
• After installation, if it is noted that your touch sensor is overly sensitive or is cycling, please see this article for assistance.

• The touch sensor can be placed near the top of the console. It is located on the opposite side (side further from the IR senor) when compared to the Hispeedido TFT GBC kit.

WARNINGS:

• Test before installation! When you receive a backlight/LCD kit, you should perform a dry run before installing to assure that nothing has been damaged in transit. A dry run or test fit means the kit is not installed in the shell. This includes the use of adhesives, brackets, and any performed soldering. All ribbon cables should have no bends or creases in them. If you are unsure how to perform a dry run, please contact our support team and we will be happy to help. Backlight kits that have been installed are not eligible for replacement or return.
  
• LCD may break if put under too much pressure or dropped. Please exercise extreme caution when installing.
• Damage to console or LCD may occur if you do not trim the cartridge port pins. Exercise caution when trimming pins, wear eye protection to protect from pin debris when cutting the metal. Damage caused by these pins are not covered under our return or exchange policy. Trim the pins of your Gameboy’s cartridge slot flat so that they don’t interfere with any parts of the kit. We also recommend placing some Kapton tape over the trimmed pins to prevent any shorts.