Game Boy DMG Q5 3.1″ Laminated IPS LCD Backlight Kit with OSD – HISPEEDIDO

**This kit is strongly recommended to use with these shells only**

The Game Boy DMG Q5 3.1″ Laminated IPS LCD Backlight Kit with OSD is a full size modern IPS backlight for your original DMG game boy. This LCD is a formidable upgrade and has a PCB replacement for those of you who may be looking for a replacement LCD. There is finally a solution for those who have broken or damaged their LCD or ribbon cable during a backlight installation.

FEATURES:

• OSD functionality.
• Contrast wheel replaced with brightness adjustment and color modes.
• Built-in 8 color modes. Each ‘color mode’ can be adjusted and color modes can change to 65,536 different colors.
• Battery level indicator on screen.
• LCD pre-adhered to glass lens.
• Retro pixel Effects: Normal, Scanline.
• Frame Blending.
• 16 pixels to 1 pixel. Integer scaling. 
• 720p display resolution ratio.
• Adjustable image position.
• Display area is 11% larger than the original.
• Only speaker soldering required (not included). Almost solderless.
• Depending on your shell, modifications may be required. If your shell is not pre-cut for a laminated LCD, modification will be required and is not recommended.
• We only recommend using a custom laminated shell from Hispeedido. Shell modification required for all other shells. No refunds are given if a non-recommended shell is used.

INCLUDED:

• 1x Q5 IPS Laminated LCD
• 1x Large front PCB
• 1x Small PCB
• 1x Large ribbon
• 1x Small ribbon
• 1x Adhesive mounting strip

PAIRS WELL WITH:

• Game Boy DMG Prestige Buttons
• Game Boy DMG Laminated IPS Shell – HISPEEDIDO

DOCUMENTATION:

• Install Guide
• How to test your LCD kit

NOTES:

To use brightness, color, and OSD features on contrast wheel:

• Cycle normally for brightness
• Short press (one to two seconds) then cycle for color
• Long press (five seconds) to enter OSD (On Screen Display) mode.

WARNINGS:

• You do not need to purchase a separate lens. Removing pre-adhered lens from LCD can result in damage to the LCD and will void product warranty. If you received an extra lens in your order, this was likely a included plastic lens with a shell and should NOT be placed on top of the pre-adhered lens.
• Test before installation! When you receive a backlight/LCD kit, you should perform a dry run before installing to assure that nothing has been damaged in transit. A dry run or test fit means the kit is not installed in the shell. This includes the use of adhesives, brackets, and any performed soldering. All ribbon cables should have no bends or creases in them. If you are unsure how to perform a dry run, please contact our support team and we will be happy to help. Backlight kits that have been installed are not eligible for replacement or return.
• LCD may break if put under too much pressure or dropped. Please exercise extreme caution when installing.