Game Boy Color Retro Pixel 1.0 Q5 IPS LCD Backlight Kit – FunnyPlaying

• The leads of the START and SELECT buttons are retained on the ribbon.
• START + touch = increase brightness
• SELECT + touch = decrease  brightness
• Press START and SELECT simultaneously for 1 second to switch the display effect. (Short press the sensor button to cycle 7-segment brightness adjustment, long press to switch the display effect.)
• To Move Left and Right: Hold Start and Select for 5 seconds, pressing start and select will then shift screen. Press touch sensor to swap direction you are moving. Press touch sensor two more times to go back to moving left and right. Save by holding start and select again for 5 seconds. 

BUILT-IN 5 DISPLAY EFFECTS:

• Full pixel copy display (display the highest brightness, gorgeous and concise)
• Classic GBC display (perfectly restore the original display effect)
• Classic RGB display (perfectly restore the original display effect, and the pixel gap looks smaller, the brightness will be slightly darker)
• RGB display (closest to the original display, but the brightness is very low)
• Grid line display (close to the display effect of DMG)

PAIRS WELL WITH:

• Game Boy Color Q5 IPS LCD Brackets
• Game Boy Color IPS Q5 Glass Screen Lens
• Game Boy Color Prestige IPS Ready Shell

DOCUMENTATION:

• Install Guide
• Install Video- NOTE: Please refer to install guide before using the video. Guides will have very important information and steps needed that the videos may lack.
• How to test your LCD kit *Soldering may be required to dry test this kit. Soldering the power wire in this case will not void the return policy.
• Shell Trim for OEM and non-IPS modified shells
• Shell trim for Prestige IPS ready shell

NOTES:

• This kit now has a touch sensor already included on the black ribbon cable. You may use this one by simply folding into the front or back of the shell. A separate touch sensor ribbon is no longer included.
• After installation, if it is noted that your touch sensor is overly sensitive or is cycling, please see this article for assistance.

WARNINGS:

• Test before installation! When you receive a backlight/LCD kit, you should perform a dry run before installing to assure that nothing has been damaged in transit. A dry run or test fit means the kit is not installed in the shell. This includes the use of adhesives, brackets, and any performed soldering. All ribbon cables should have no bends or creases in them. If you are unsure how to perform a dry run, please contact our support team and we will be happy to help. Backlight kits that have been installed are not eligible for replacement or return.
• LCD may break if put under too much pressure or dropped. Please exercise extreme caution when installing.
• Damage to console or LCD may occur if you do not trim the cartridge port pins. Exercise caution when trimming pins, wear eye protection to protect from pin debris when cutting the metal. Damage caused by these pins are not covered under our return or exchange policy. Trim the pins of your Gameboy’s cartridge slot flat so that they don’t interfere with any parts of the kit. We also recommend placing some Kapton tape over the trimmed pins to prevent any shorts.